| Add： |
Chaoyang District Wangjing Beijing garden building 25, 6032 |
| Tel： |
400-168-5636 |
| Fax： |
400-168-5636 |
| Email： |
upschinagroup@163.com |
| SiteUrl： |
http://www.szsatkups.com |
|
|
| Santak power supply use, you trust the regulator |
| Time：2015-12-22 Source： Views：3671 |
| Using the advanced voltage reference suspended superposition technique and linear series adjustment and Quan Xinyan of regulated power supply manufacturers to provide a regulated power supply. The series products are stable and stable, good stability, low ripple voltage, with the output voltage, over current and other protection functions, the output voltage can be adjusted from zero to the rated value, the output current can be preset to the rated value. The pre stable circuit adopts thyristor and relay group control, so that the voltage across the rectifier bridge is stable, and the pressure drop is relatively stable, so that the whole machine has the characteristics of small size, high efficiency, good stability and so on. Regulated power supply is widely used in industrial and mining enterprises, transportation, colleges and universities, health, radio stations, hotels, scientific research units, communications, banking, securities such as government agencies, especially in computer network, radio communication equipment, traffic signal system, test equipment, import design equipment and automated assembly line etc., also apply to low supply voltage, large fluctuations in the low end of the distribution network users. Regulated power supply manufacturers explain regulator reasonable installation procedures and maintenance skills: first, the regulator input received distribution board and on the user panel placement for the instrument power guaranteed rate of fuse, to ensure safe use of electricity. Second, the power supply of electric facilities to the output terminals of the instrument, the attention of the rated input voltage value of the voltage should be consistent with the output of the regulator, do not take the wrong. Third, first open the power switch, the power switch, the work indicator light. To observe whether the indicator values are normal. When the output voltage is normal, and then open the power switch, the voltage regulator can automatically adjust the voltage, normal power supply. Fourth, when using the electric facilities for a long time, please turn off the power switch to reduce power consumption and prolong the service life of the regulator. Fifth, the regulator shall not overload the use of. When the power voltage is low, the output capacity is reduced, and the load of the regulator should be reduced accordingly. Sixth, when the admission appliances have refrigerators, air conditioning, water pumps and other facilities, should choose to 3 times the capacity of the regulator, to avoid the device to start current over voltage regulator fuse current or over current protection circuit breaker current to fuse or circuit breaker tripping or pressure drop is too large and can not work. Seventh, the conductor with the regulator should be sufficient to prevent heat and reduce the pressure drop. Capacity of above 2KVA regulator with terminal connection, should admit single copper wire, and try to tighten the screw terminals, to prevent heat cohesion. Eighth, whether single or three-phase voltage regulator, after all the input and output lines, should switch off the load of the power switch, and then open the regulator, check out the normal output voltage, and then open the load switch. |
|
Your Current Location：